Marshall Electronics Network Control Box for IMD Monitors NCB-1004 Instruções de Operação descarregar pdf (Página 19)

Web Interface (continued)

OSD Configuration & IMD

The OSD Configuration & IMD page is shown below:

Use the first section of the OSD & IMD page to set the protocol pass-through settings:

o Set Protocol (Image Video, TSL) – Select the protocol type to be passed through the NCB-1004. Note that

this option must be set according to the protocol that is applied to the Control In input on the NCB-1004.

o Pass-Through (On, Off) – Enable or disable the pass-through of Image Video or TSL protocol.

o Read Protocol Type – Refresh the Protocol Type display in the Target Monitor page.

o Read TSL Status – Read the TSL error status. Results are displayed in the Message Box at the bottom of the

page.

Use the left-hand section of the page to configure the OSD with following commands:

o IMD State (Off, On)

o Status Display (Off, On)

o Timecode (Off, LTC, VITC)

o Audio Monitor (Off, On)

Use the left-hand section of the page to configure the In-Monitor Display:

o Show IMD Address – This command displays the current of each monitor on each screen.

o Set IMD Intensity (0-100)

o Send IMD Alignment (Left, Center, Right) – Set the fixed string alignment of a monitor.

o Send IMD Color (Red, Green, Yellow/Amber) – Set the fixed string color of a monitor.

o Send IMD String – Set the fixed string in a monitor.

o Send IMD Name – Set the IMD Name (S/N) of a monitor.

o Get IMD Name – Get the IMD Name (S/N) of the selected monitor.

o Show IMD – Show the fixed string on a monitor.

o Show IMD Name – Show the IMD Name on a monitor.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Sem comentários

Marshall Electronics Network Control Box for IMD Monitors NCB-1004 Instruções de Operação Página 19